|
Click picture to enlarge
|
|
View of ramps attached to vehicle with the safety pins in place.
|
|
This is a rear view of an ambulance with the ramps in place.
|
|
We supply a cable roller to protect the body of the ambulance. All we need is the diameter and the center-to-center distance between the door striker pins.
|
|
Here is the cable roller in action.
|
|
Safety catch in place to prevent the bed from rolling down the ramp should the cable snap.
|
|
Receivers are built into the back of the vehicle to properly locate and secure the ramps.
|
|
Side view of block sliding into receiver.
|
|
Ramps installed into reciever.
|
|
Ramps in storage compartment.
|
|
Each block is custom made to fit the back of the specific ambulance.
|
|
This is an example of two different styles of blocks for two different vehicles.
|
|
The hinges are machined from solid aluminum block for extra strength.
|
|
The recevier bar is custom made and fitted to each ambulance.
|
|
Example of block fit into receiver.
|
